|
MOCD207Monsemi / Fairchild
|
x 1 | |
|
1751264Phoenix Contact
|
x 2 | |
|
RCG08050000Z0EAVishay / Draloric
|
x 2 |
|
EagleAutodesk
|
2 Channel Opto Coupler
This small board will allow you to opto-isolate two discrete signals. Very useful in situations where you require galvanic isolation or have isolated DCDC converters. It uses the standard MOCD207M with large Phoenix screw connectors. These can either be used or wired directly into the device. Any 0805 resistor will work on this board, but ensure you select the correct value to prevent overcurrent on the opto isolator.
Use LED Calculator & a LED voltage drop of 1.25V @ 30mA to calculate a near known resistor value.
If you are using this to add a NPN transistor to a circuit, you can solder the pads to short + & GND to the opto isolator. In this mode it will act similar to a NPN switch.
Ensure you match the input & output voltages & currents correctly to prohibit damage to any device or system that may be connected to this device.
2 Channel Opto Coupler
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Luke Pallot
-
Commodore 1551 Drive Cartridge Replacement
145 0 2 -
RCMHardwareByte-v2.3
108 0 0 -
Terminal Curiosity PCB Ruler
319 0 1 -
(DIY) COMMODORE 64 DEAD-TEST (781220) DIAGNOSTIC CARTRIDGE
365 0 2 -
Creative Micro Designs Inc. CMD FD-2000 / FD-4000 3D Printable Case
397 0 0 -
Creative Micro Designs Inc. CMD FD-2000 / FD-4000 Metal Case
565 0 0 -
-